Changing motor oil is maintenance that must be carried out by every vehicle owner. Not only maintaining vehicle quality, but also maintains the motorbike's performance so that it remains optimal when driving. If you have free time, try changing your vehicle's motor oil yourself. By doing this, We can save on motorbike maintenance costs by not paying service fees from mechanics. The following are tips for changing motorbike oil independently that Otodiva.com has quoted from Revzilla. Yuk, take a look!
Remove the oil
Before starting, Don't open your radiator cap while the motorbike is still hot. You need access to the radiator cap, water pump, holding tank, funnel and oil. Position your drain pan under the water pump. Locate the oil drain plug on your motorbike, Usually the small bolt is at the bottom of the water pump cover, then release and the oil will flow out. Open your radiator cap, and the flow will increase significantly. The final flushing job required is the reservoir tank. Usually a clear plastic container that is tucked near the engine or in the tail, You will need to remove any old oil fluid stuck inside.
Prepare new oil
While you wait for the old coolant to dry, prepare your new cooler. Diluted coolant can be entered directly, but if not, You must mix the concentrate with distilled water. Avoid the temptation to use regular tap water, because minerals and other debris may not be compatible with your cooling system.
Tilt the Motor
After most of the coolant has drained, stand the motor and tilt it from side to side to remove any remaining coolant. This is especially important if you are changing the coolant type, because you should not mix different coolants. If you notice dirty deposits building up, remove the reservoir from the motor, install the hose connection, and pour isopropyl alcohol with a spoonful of table salt. Vigorous shaking will remove most stains and dirt. Rinse with distilled water before reassembling.
Add oil
Finally, You can pour oil liquid into the filler neck of your motorbike oil system through a funnel. Reduce spillage by pouring slowly into the funnel, then pause to listen to the gurgling sound of the system charging. Start pouring again when the sound stops. Your motorcycle may require less than its full capacity when you first fill it up, but don't worry. Once the system is full, Remove the radiator cap and run the motor for one minute. A few quick turns will remove any remaining air bubbles. Turn off the motorbike, double check your levels, and add coolant as necessary. Fill the reservoir tank until it is full, install the radiator cap, and you're ready to ride.
Those are tips for changing motorbike oil independently. Do this if you want to save money on maintaining your motorbike.
Read Also, Be careful Girls! These are some of the causes of car oil running out quickly
