To install this one component on the headlight, You need to pay attention to the condition of the far and near light cables in the sockets and the different cable colors, It all depends on the type of motorbike used.
Quoting from Otosia, Usually the legs on the relay will be marked with several numbers as markers, like
30, 85,86, 87 with different positions, depending on the type of relay. You can use this pattern if you have a motorbike with DC electricity. The characteristic of a motorbike with DC electricity is that it can turn on the lights even if the engine is off.
For far and near lights, use separate relays, so if you want to use just one lamp, install the required relays. This type of lamp uses a relay with 4 legs.
Meanwhile, for motorbikes that use AC type electricity, like in ducks and automatics, the electricity will turn on if the engine is on. This circuit has the function of transferring the lamp voltage source from the spool to the battery.
This type of AC electricity has advantages, that is, it still lights up brightly even though the engine is at low rpm. For light bulb type, You can use a larger wattage than the original.
Relay installation can be done in the cable route area before the far and near light switches. Like if the on-off light switch is on the right side of the handlebar panel while the far-near light switch is on the left handlebar area., then the relay circuit is installed on the cable that connects the cables on the right panel and left panel.
Read too : Here are safe tips for you to maneuver while driving
