The alarm contained in a car is intended to protect the car from theft crimes. This alarm can be operated via the remote found on the car key. However, There are times when you must have experienced that your car remote is dead or jammed.
Usually the alarm will sound when someone tries to force the car to open or is simply hit by vibrations. A common problem is that the alarm sounds but the remote is not working.
This is certainly disturbing, especially when the car is parked in front of the house, because it can disturb the peace of other people due to the sound of the alarm. But, you don't worry, because this can be overcome in several ways. Reported from several sources, Here's how to turn off a car alarm when the remote is broken.
Starting the Car Engine
When the car alarm is on, Otolovers can immediately start the car so that the alarm can immediately go off. The first thing you have to do is open the car door manually with the car key and then just start the engine as usual. When it's done, The car alarm will automatically turn itself off because the key has been detected by the sensor.
Open the door
As explained above, You can also turn off the alarm using the car key. However, You have definitely made some mistakes, the problem is forcing the remote on the lock to work.
Even though the remote is no longer functioning normally, therefore you only need to insert the car key into the door, then turn it to the lock position. Then rotate it to open it several times. This is because when you lock the car correctly and manually, The alarm will receive a signal to immediately turn off the sound.
- Reset Aki Mobile
The next step is to reset the battery so that it can turn off the alarm. you just need to remove the negative cable, but there is no need to remove the positive cable. If it's alive, don't forget to reconnect the negative cable. you are advised to be careful, in doing this way.
- Removing the Alarm Fuse
Inside the alarm there is a fuse that can be found in the manual, The position of this fuse is in the engine compartment and cabin. In doing this level a tool is needed, namely needle-nose pliers so you can remove it.
Read too : Tips for installing relays properly and correctly on motorbikes
