Floods are one of the disasters that often occur in Indonesia. It is not uncommon for several areas on the road to be flooded with water up to several meters. Of course, this causes quite large losses, including in terms of transportation. Flood disasters cause widespread damage to life, starting from property to modes of transportation such as motorbikes.

Motorbikes that have been submerged in floodwater can experience two levels of damage. First, the motorbike is submerged until the entire body or water surface is above the air filter. Second, The motorbike is only submerged until half the body or the water surface is below the air filter. Nah, Below Otodiva.com has summarized several correct ways to deal with your motorbike after it has been submerged in a flood. Let's look at the tips together!

The first step you have to take is when the motorbike is submerged in flood water at a level below the air filter, Clean the motorbike with clean water. This is done to anticipate rust on motorbike parts that are submerged in floodwater due to dirt and crust sticking to the motorbike components.. You also have to ensure that water does not enter the air filter area through indications that can be seen in the traces of water flowing on the air filter area and also the exhaust..

If in doubt, then remove the spark plug first, then crank the engine using the kick starter several times to ensure or clean the cylinder chamber if there is water that enters the cylinder even in a small amount. If the spark plug is wet, try to dry and brush it. After the spark plug is dry, Reinstall it carefully so that the spark plug thread is not damaged. You need to be careful with this step to avoid further damage.

If the motor cannot be started, Try checking the CVT tub and then cleaning it. Make sure it is free from water seepage. Then, Check other parts such as the crankcase, behind clutch, cylinder block, cylinder head, and carburetor. So, if there are some parts that need to be soaked, So choose a fluid that neutralizes acidity so that your motorbike engine doesn't rust quickly.

Furthermore, also monitor the air filter. When the air filter is wet, then it can be replaced or simply dried according to the type of air filter on your motorbike. Besides that, Also check the oil. If the oil is grayish brown, This is a sign that the oil has been mixed with flood water. If it's like that, immediately flush. When not done, It is feared that the engine will become more damaged if it is forced to run.

Read Also, Listen, Things You Should Consider Before Motorcycle Loans

Share.
Leave A Reply

Exit mobile version